How you can Install ElectroPod LED Kits

From vibrant blues to radiant yellows, LED lights can produce a vibrant glow when they are placed on your automobile. Individuals searching to include this LED addition for their vehicle -- including motorcycles, cars, trucks, ATVs and snow sleds -- can install an ElectroPod LED package. Affixing this package for your vehicle can be achieved in your own home. When it is installed, transform it onto illuminate your ride.

        1

        Determine the preferred position from the ElectroPod's LED accent coffee pods and lightweight bars. These locations ought to be over a feature you want to focus on. For instance, placing the LEDs underneath the steering column or vehicle's gas tank will illuminate the vehicle's engine, while mounting LEDs underneath the front and back wheel wells can give the tires a vibrant glow.

        2

        Clean the top of area where you want to add the LEDs. Make sure it is free from grime, dirt and mud to ensure that the fixture can certainly adhere.

        3

        Adhere one for reds of double-on the sides foam tape to the rear of the LED light bar or accent pod. This adhesive may have include the package.

        4

        Put the LED fixture around the preferred location in your vehicle using sleep issues from the foam tape.

        5

        Squeeze on/off switch from the package within an readily available location. Ensure this switch won't slow down or block other vehicle functions and indicators. Attach it in position with double-on the sides foam tape.

        6

        Route the positive energy wires (that are red-colored) in the LEDs toward the non-fused energy wire from the on/off switch. Avoid running these wires through any area of the vehicle that may burn or destroy them, like the engine.

        7

        Strip 1/4 to threeOr8 inch from the finish from the LED energy wires and also the non-fused energy wire from the on/off switch utilizing a wire stripper.

        8

        Gather the uncovered finishes of LED energy wires and also the on/off switch's non-fused energy wire and put them right into a wire nut. Twist the wire nut around the uncovered finishes from the wires until it may no more be switched. This can secure the wires together. Make certain there isn't any uncovered wire finishes.

        9

        Route all negative wires (that are black) in the LEDs towards the on/off switch. Repeat the steps to secure them and also the on/off switch's negative wire (that is near the device's non-fused energy wire) together inside a wire nut.

        10

        Release battery devices from the vehicle's battery. Every battery differs, so stick to the battery manufacturer's instructions if you are unclear about how you can release them.

        11

        Strip the on/off switch's other negative energy wire, that is found near the fused energy wire. Wrap the wire round the negative battery publish. Tighten the terminal in place. Continue doing this process using the positive fused energy wire from the on/off switch, wrapping it round the positive battery publish before affixing battery terminal in place.|T8 LED Tube
Tips & Alerts

    Don't mount the LEDs inside a place that may draw attention away from you varieties while you are operating the automobile.

    Some states stop specific light colors on the outside of of automobiles. Seek advice from your state's laws before setting up an ElectroPod LED package.

    Continually be careful whenever using electricity.