How to adapt to LED lights

An LED flashlight inside to replace incandescent bulbs - to provide a more long-lasting battery needs less light. In order to adapt the light an LED flashlight inside, modify, which accommodate the bulb lamp module. Most homes have a number of tools on hand, will need to LED DownLight, from a hobby shop or electronics store purchase.

         1

         Unscrew the flashlight at the end of the battery cover and remove the battery. Unscrew the flashlight inside the incandescent bulbs, and remove it.
         2

         Flashlight into the front of the needle nose pliers. Clamp jaws grip the edge of the incandescent bulbs of the General Assembly. Pull of the General Assembly, and discard it in the trash.
         3

         Unscrew the lid from the LED module assembly. Open end up standing on a table in the LED module assembly.
         4

         Base of the LED diode light grip and keep the bottom down with the two additional pins. Insert a short two pins on the LED in the LED module assembly center bottom of the hole. Insert the other pin hole to center hole on the right bottom of the LED diode lights. Push down firmly on the seat assembly within the LED Module light .
         5

         Heating iron to 3 minutes. Welding the bottom end of the LED module assembly contact one of the two conductive pins. Welding the end of the spiral contact other conductive pin contact, is a corner. Let the solder cool 2 minutes. Unplug the iron.
         6

         First, the Super Flux LED Module assembly, conductive pin, to the flashlight. Flashlight into the General Assembly, until you feel some resistance. Screw reflected. Insert the battery and battery cover screw.